Honda Accord: Cruise Control Combination
Switch Test/Replacement
SRS components are located in this area. Review the SRS component locations:
2-door fsee page 24-23)
4-door (see page 24-21)
Precautions and procedures (see page 24-25), in the SRS before doing repairs or service.
1. Remove the driver's airbag (see page 24-211).
2. Disconnect the cable reel subharness 20P connector.
3. Check for continuity between the terminals in each cruise control combination switch position according to the table.
- If there is continuity, and it matches the table, but the cruise control combination switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the cruise control combination switch (see page 17-7).
Cruise Control Input Test
NOTE: Always make sure that you have the latest Honda Diagnostic System (HDS)
software.
1. Connect the HDS to the data link connector (DLC) (see step 2 on page 11 -3).
2. Turn the ignition swi ...
Clutch Pedal Position Switch
Test
M/T model
1. Disconnect the clutch pedal position switch 3P
connector (A).
2. Remove the clutch pedal position switch (B).
3. Check for continuity between the terminals according
to the table ...
See also:
Accessory Power Socket Trim
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the console.
- Use the approp ...
Oil Pan Installation
1. Remove all of the old liquid gasket from the oil pan
mating surfaces, the bolts, and the bolt holes.
2. Clean and dry the oil pan mating surfaces.
3. Apply liquid gasket, P/N 08717-0004,0871 ...
Disc Changer Error Messages (Models with navigation system)
The chart on the right explains the
error messages you may see in the
center display while playing a disc.
If you see an error message in the
center display while playing a disc,
press the ej ...