Honda Accord: Driver’s Seat Power Adjustments - Seats - Instruments and Controls - Honda Accord 2008-2012 Owner's ManualHonda Accord: Driver’s Seat Power Adjustments

Except LX and EX

See for important safety information and warnings about how to properly position the seats and seatbacks.

The controls for the power adjustable driver’s seat are on the outside edge of the seat bottom. You can adjust the seat with the ignition switch in any position. Make all seat adjustments before you start driving.

The front passenger’s seat adjusts manually.

Moves the seat forward

and backward. Moves the seat forward and backward.

seat up or down. Moves the front of the seat up or down.

Moves the whole seat up Raises or lowers the seat.

and forward, or down Moves the whole seat up and forward, or down and backward. The front of the seat also tilts up or down at the same time.

angle forward or Adjusts the seat-back angle forward or backward.

the lumbar support. Increases or decreases the lumbar support.

U.S. V6 models, and Canadian EX-L and V6 models with navigation system

The driver’s seat includes a memory feature. Two seat positions can be stored in separate memories. You can then select amemorized position by pushing the appropriate memory button. Refer to page for how to memorize and select the seat positions.

    Seats
    ...

    Front Seat Manual Adjustments
    See pages for important safety information and warnings about how to properly position the seats and seatbacks. Make all seat adjustments before you start driving. To adjust the seat forward ...

    See also:

    Ball Joint Removal
    Special Tools Required - Ball Joint Thread Protector, 14 mm 07AAE-SJAA100 - Ball Joint Thread Protector, 12 mm 07AAF-SDAA100 - Ball Joint Thread Protector, 10 mm 07AAF-SECA120 - Ball Joint Remover ...

    Using the Remote Transmitter
    Press the trunk release button for approximately one second to unlock and open the trunk. ...

    Status Log
    If you suspect there is a immobilizer system problem, check the status log. 1. Connect the HDS to the data link connector. 2. Turn the ignition switch to ON (II). 3. On the HDS screen, at MAI ...