Gauges

...

Self-diagnostic Function

NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). The gauge control module has a self-diagnostic functio ...

See also:

A/C Signal Circuit Troubleshooting
NOTE: • If the blower motor does not run at all speeds, the A/C compressor will be inoperative. Run the self-diagnostic function, and check for DTC B1241. Before performing any other troubl ...

Main Valve Body Disassembly, Inspection, and Reassembly
1. Clean all parts thoroughly in solvent, and dry them with compressed air. Blow out all passages. 2. Do not use a magnet to remove the check balls, it may magnetize the balls. 3. Inspect the ...

Lower Arm Removal / Installation
Special Tools Required - Ball Joint Thread Protector, 14 mm 07AAE-SJAA100 - Ball Joint Remover, 28 mm 07MAC-SL0A202 - Bushing Driver 070AF-TA0A100 - Bushing Receiver Set 070AF-TA0A220 Removal/Ins ...