Honda Accord: Circuit Diagram - Seat Heaters - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Circuit Diagram

 


 

Seat Heater Test


    Component Location Index
    ...

    Seat Heater Test
    Driver's Seat 1. Remove the driver's seat (see page 20-194). 2. Remove the seat back panel. • 4-door (see page 20-221) • 2-door (see page 20-213) 3. Disconnect the connector A (4P) ...

    See also:

    Electrical Compass Zone Selection and Calibration
    NOTE: • You should do this procedure any time the electrical compass unit is replaced. • You should do this procedure in an open area away from buildings, power lines, and other vehicl ...

    CMP Sensor A Replacement
    1. Disconnect the CMP sensor A 3P connector (B). 2. Remove CMP sensor A from the intake camshaft side of the cylinder head. 3. Install the parts in the reverse order of removal with a new O-ri ...

    Mainshaft Disassembly, Inspection, and Reassembly
    1. Inspect the thrust needle bearings and the needle bearings for galling and rough movement 2. Inspect the splines for excessive wear and damage. 3. Check the shaft bearing surface for scorin ...