Brakes

Design Specifications

See also:

Electrical Compass Zone Selection and Calibration
NOTE: • You should do this procedure any time the electrical compass unit is replaced. • You should do this procedure in an open area away from buildings, power lines, and other vehicl ...

Cylinder Head Installation
1. Install a new coolant separator (A) In the engine block whenever the engine block is replaced. 2. Clean the cylinder head and the engine block surface. 3. Install the new cylinder head gaske ...

System Description
HandsFreeLink Control Unit Inputs and Outputs HandsFreeLink Control Unit 28P Connector *l:The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insula ...